![]() FireSIGHT Management Center FS2000, FS4000 or virtual appliance. ![]() These components are required on the Cisco FireSIGHT Management Center: Note: If you want to install FirePOWER (SFR) Services on an ASA 5585-X Hardware Module, refer to Install a SFR Module on an ASA 5585-X Hardware Module. FirePOWER Software Version 5.3.1 or later.Cisco ASA platforms 5512-X through 5555-X.Cisco ASA software Version 9.2.2 or later.In order to install the FirePOWER Services on a Cisco ASA, these components are required: If a password was not set, then press Enter: In order to access the privileged EXEC mode, enter the enable command into the CLI. Ensure that you have access to the privileged EXEC mode.Ensure that you have at least 3GB of free space on the flash drive (disk0), in addition to the size of the boot software.Prerequisites RequirementsĬisco recommends that your system meet these requirements before you attempt the procedures that are described in this document: This document describes how to install and configure a Cisco FirePOWER (SFR) module that runs on a Cisco Adaptive Security Appliance (ASA) and how to register the SFR module with the Cisco FireSIGHT Management Center.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |